propeller shaft

...the propeller shaft.

螺旋桨的传动轴

Install the straps and bolts to hold the propeller shaft to the yoke.

安装扣夹和螺栓,将传动轴固定到轴轭上.

Aligning intermediate shaft and propeller shaft after launching.

下水后中间轴和螺旋桨连接后校中.

Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference.

在传动轴和传动轴轴轭 、 或小齿轮轴轭上作标记, 作安装的参考标志.

The propeller shaft may be solid or hollow, protected by an outer tube or exposed.

传动轴可以是实心的或空心的, 由套管加以保护或裸露在外.

Remove the rear propeller shaft.

拆卸后传动轴.

Different nacelle with deeper ross-section and intake over propeller shaft.

发动机舱、螺旋桨轴处的进气口有一些不同.

When taking propeller shaft joint angle measurements, or checking the phasing, of two piece shafts, consider each shaft separately.

当测量两个传动轴的工作角或检查它们是否定相时，对它们要分别考虑。

Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft.

对准传动轴和轭上安装参考标记,安装传递轴.

There must be one or more universal joints to permit variations in the angle of drive. There must also be a slip joint that permits the effective length of the propeller shaft to change.

可轴向移动的球笼式万向节一个或几个万向节来适应传动角度的变化；一套伸缩花键，能够改变传动轴的现有长度。

Disconnect the axle or end of the propeller shaft or the universal joint, according to type.

根据变速器的类型,拆下后桥或者传动轴或者万向节.

The power enters the differential through the drive pinion on the end of the propeller shaft.

也就是说,驱动力是从传动轴末端的传动齿轮输送到差速器的.

Inspection machining dimension of propeller shaft ( intermediate shaft or counter shaft ).

螺旋桨轴 ( 间轴 ) 加工尺寸检查.

Align previously made marks on yoke and propeller shaft and install propeller shaft.

将定位轭架上的预制标记对准传动轴并安装传动轴.

Nothing seems to be wrong with the propeller shaft.

转动轴看来没毛病。

Measuring clearance between propeller shaft & bearing.

螺旋桨轴 与 轴承间隙测量.

The propeller shaft frequency is one of the important target recognition features for passive sonar.

螺旋桨轴频是被动声纳极其重要的目标识别特征之一.